Modeling, animations, sounds
All discussion and support on models, animation and sound.
516 topics in this forum
-
- 2 replies
- 573 views
-
- 2 replies
- 527 views
-
- 1 reply
- 698 views
-
- 1 reply
- 436 views
-
- 4 replies
- 989 views
-
- 4 replies
- 1556 views
-
- 2 replies
- 1131 views
-
- 2 replies
- 622 views
-
- 11 replies
- 2087 views
-
- 10 replies
- 902 views
-
- 3 replies
- 730 views
-
- 3 replies
- 592 views
-
- 5 replies
- 1523 views
-
- 8 replies
- 489 views
-
- 3 replies
- 917 views
-
- 0 replies
- 406 views
-
- 3 replies
- 1098 views
-
- 3 replies
- 548 views
-
- 8 replies
- 580 views
-
- 3 replies
- 583 views
-
- 1 reply
- 422 views
-
- 0 replies
- 374 views
-
- 6 replies
- 688 views
-
- 2 replies
- 615 views
-
- 5 replies
- 461 views
-
Popular Topics
-
-
Latest Posts
-
The specs of this NAS are impressive 👌(So is the pricetag). I am assuming that those 2 1Gb disks are SSD's setup for additional caching 😉 I am currently already on a 1Gb LAN. Not shure whether this is fast enough. Upping the networkspeed would mean for me also replacing modem/router, switches (1 Gb ports) and cabling (Cat 5e). Price is only one aspect. This mapping of shares to a drive letter makes things easy. I however remember that some addon software had problems with showing up of mapped drive letters in f.e. dialog boxes, depending on the language used for developing the addon.(The dev pointing to Microsoft and Microsoft to the dev,...) This was a long time ago. Software evolves and this works for you, so I can safely assume that it will work for me too. I wish I had not read your post, as I am in now for some sleepless nights before deciding which road to take🤔 Thank you for sharing Johan -
Hello, Here you have a couple of screenshots and the log. Greetings, Jordi Log.txt
-
You should not use Lorby for such tasks! In Orbxcentral under settings you should use the Library insertion point to move all Orbx addons, to the correct position. Using Lorby can have unforeseeable side effects. -
-
Hello Mark, Many thanks for your reply, I really appreciate it! I am clearly missing many steps in the merging, converting and flipping process. I might be OK with merging and converting however, but flipping is something new to me. :)) I will nevertheless try the steps you wrote above and hopefully I will succeed. In any case, is there perhaps a step-by-step guide for the entire process? It would defintely help a lot. Thanks and regards, Dénes
-
