Twin Otter Extended

Support for the Aerosoft Twin Otter Extended

909 topics in this forum

    • 4 replies
    • 750 views
    • 2 replies
    • 511 views
    • 0 replies
    • 321 views
    • 8 replies
    • 1279 views
    • 3 replies
    • 847 views
    • 3 replies
    • 562 views
    • 11 replies
    • 1588 views
    • 3 replies
    • 626 views
    • 3 replies
    • 1001 views
    • 3 replies
    • 390 views
    • 2 replies
    • 1090 views
  1. Twin Otter Crashes FSX

    • 9 replies
    • 773 views
  2. Fuel Planner Planned FL

    • 3 replies
    • 502 views
    • 4 replies
    • 347 views
  3. Cockpit went blank

    • 1 reply
    • 271 views
    • 4 replies
    • 1115 views
    • 6 replies
    • 887 views
    • 2 replies
    • 376 views
    • 3 replies
    • 1260 views
  4. Slow Throttle

    • 4 replies
    • 1140 views
  5. DHC6 Tiller

    • 2 replies
    • 437 views
    • 5 replies
    • 511 views
    • 2 replies
    • 586 views
    • 2 replies
    • 329 views
  6. No Engine Sound

    • 2 replies
    • 355 views
  • Posts

    • Nein ist alles OK. X Plane 11.32r1.   Gruß Martin.
    • Hallo zusammen habt ihr auch wider probleme mit demm echtwetterdaten? bei funktionert es schon wider nicht mehr.😬
    • Sorry! You´re right! It´s the same to me. I don´t know too. Excuse me for beiing a little quickly. Just wanted to help. Greetings!
    • reposted as requested with an update after..   I have not seen this issue on any flight before. 149.2 ZFW 23.6 fuel both weights in lbs   KSEA to KPHX Ran into the managed speed issue that still happens but for me at least very rarely now.  After switching the arrival rwy in the MCDU the problem went away as before, but now I am climbing at less than 500 ft/min in managed mode with a CI of 80.  My epr is 1.517 and the CLB rating shows 1.519.  I have flown this heavy in the past with no issues.  If I go off A/T or push the levers to max nothing changes with regard to engine output.  I show the modes as THR CLB    CLB    NAV.  All MCP buttons are pushed to the plane.     Is it just the weight?  I mean I flew earlier at 148 zfw and the climb was what I call airbus slow...slow but normal from what i have exprerienced....   Flew the exact route again. Same time/day/wx/  Same load sheet from the aerosoft load manager.  Normal behavior this time...it's a real head scratcher.  My MCDU preflight is always the same as I run a checklist on that.     On another note.  I have found that if I begin my descents about 40nm from where the TOD is predicted, my managed descents, speeds and target altitudes are all spot on until A/P off for landing.  It would seem that the calculated TOD's are somehow past where they should be.....
    • Hello again, unfortunately the steps you recommended did not help, and I somehow messed up my drivers in the process 😞. I will hopefully get back to you in the future after I try more things.  Anyhow, thank you very much for your assistance sir.