Soaring Flights in FSX
General discussion regarding soaring with and without missions
22 topics in this forum
-
- 8 replies
- 13.9k views
-
- 0 replies
- 9.4k views
-
- 1 reply
- 9k views
-
- 7 replies
- 13.9k views
-
- 3 replies
- 23.2k views
-
- 0 replies
- 9.3k views
-
- 6 replies
- 10.1k views
-
- 3 replies
- 9.6k views
-
- 0 replies
- 9.2k views
-
- 1 reply
- 8.7k views
-
- 7 replies
- 9.6k views
-
- 5 replies
- 12.1k views
-
- 5 replies
- 17k views
-
- 0 replies
- 8.9k views
-
- 12 replies
- 10.9k views
-
- 4 replies
- 10.6k views
-
- 0 replies
- 9.3k views
-
- 0 replies
- 9k views
-
- 13 replies
- 11.8k views
-
- 1 reply
- 10.1k views
-
- 1 reply
- 9.4k views
-
- 13 replies
- 11.3k views
-
Popular Topics
-
-
Latest Posts
-
Intercepting heading, yes oc, but in my case i was on track already. SID was a straight out departure with a easy turn about 9 miles out. And as i said, switching NAV mode after takeoff (w/o autopilot on) worked. Only Arming NAV on the ground didn't do what i was expecting it to do, except showing it "Armed" (white). I was only trying to fly the SID manually and get the appropriate FD directions and hit the AP at a later stage.... All good ! I hope the AS team will have time to check. (On the ground, arming NAV before TO) Oliver -
By Bill Zarkov · Posted
Simple question - when I have the AP in NAV following FMS1 and get in range of ILS - do I need to manually switch the source to LOC1 or does it auto switch and acquire if I hit APP mode once I'm on a sane intercept? I thought it did acquire once but didn't hold it, but that could have been me getting slow and low... It works fine when I manually switch to LOC1 and I get the green needles but just wondered as it seems to be very similar to the CJ4 Collins FMC which does auto switch and acquire. -
By Bill Zarkov · Posted
I flew EGLC-EGNT and planned the RIMT1N arrival to ILS25 with vectors after ETSES (I had removed discontinuity but left vectors so I could get a reasonable intercept in HDG mode). Plan looked fine on the FMS and in PLN mode. Got to cruise and switched MFD to show VNAV - I did not see the time/distance to ToD. It stayed like that until I removed the VECTORS line on the FMS - immediately I saw the ToD and it worked fine after that. It was not ideal because it left me with a direct to FF125 which is not appropriate. My question is why I need to remove the vectors indication as that correctly describes (in my mind) the plan - it "knows" all the constraints and has the runway - seems like the very least it could do is take me to the last alt constraint before the vectors? -
By Mathijs Kok · Posted
We are very much aware of the issues with the product, but are currently unable to solve this. If you bought the product with us, contact us on support on aerosoft.com and we will arrange a solution. -
Hi, unfortunately I have not seen that yet being only an issue for the 330. May I ask you to open a Ticket here: https://helpdesk.aerosoft.com/portal/en/home ?
-
