- AEROSOFT COMMUNITY SERVICES

Jestersstick earned the One Year In badge

A year since joining

22 minutes ago22 min
brianprice49 earned the First Post badge

Making your first post

48 minutes ago48 min
phil77 earned the Week One Done badge

A week since joining

56 minutes ago56 min
phil77 earned the One Month Later badge

A month since joining

56 minutes ago56 min

Thrustmaster throttle quadrant calibration

OK - I followed the instructions in the PDF, and tried toggling the reverse axis. I think the issue is that on the EFB, when the Bravo levers are in the idle position, the raw values are -1 - not close to zero as I believe it should be. They don't hit zero until somewhere around the climb detent. I'm leaving for a while - will check back in in a few hours. Thank you for your help. BTW - I tried swapping out the Airbus lever for a regular Bravo lever - did not change the behavior.

By brianprice49 · 6 minutes ago6 min
Thrustmaster throttle quadrant calibration

Try turning the invert axis option in MSFS 2024 on or off and try recalibrating after following the advice in the above PDF. I had already tried all of that but the throttles jumped from full reverse to the climb detent completely ignoring the manual throttle zone for the Airbus. Once I toggled the Invert Axis option off and on again then it started working properly after I calibrated again. I don’t have 2020 installed anymore so cannot test it there.

By Andy B. · 39 minutes ago39 min
XPNetwork Europa

Das kannst du doch schnell feststellen: Einfach der Reihe nach die von dir vermuteten "Übeltäter"-AddOns in deiner scenery_packs.ini disablen. Ich verwende "nur" HMK_XPNetwork und simHeaven und stehe auf der 03 in LRBV. In dieser Config ist von Baufahrzeugen nichts zu sehen.

By hmkaiser · 43 minutes ago43 min
Thrustmaster throttle quadrant calibration

Please have a look to the procedure attached.
TCA-A340.pdf

By SimWare · 46 minutes ago46 min
Thrustmaster throttle quadrant calibration

I have the Bravo TQ quadrant with the Airbus lever pack. I cannot get this to operate correctly after mapping the controller in MSFS2024 and calibrating it in the EFB. I do not have any mapping for the reversers - just the axis for the throttles. When I move the levers back to idle (not past the detent) the reverser levers pull up and reversers engage. When I push the levers forward, the reversers start disengaging, and complete disengaging at the climb position (without the throttles moving forward), then once disengaged the throttles start moving forward. So basically the idle position is nowhere near where I calibrated it and the reversers are engaging without any mapping in MSFS2024. What?

By brianprice49 · 49 minutes ago49 min
Can’t switch off APU

Ich kann die APU beim Klicken auf den APU Master Switch nicht ausschalten woran liegt es

By taucherhh · 57 minutes ago57 min

Total Topics 122k
Total Posts 842.5k

Sign In

Who's Online (See full list)

Recent Achievements

Jestersstick earned the One Year In badge

brianprice49 earned the First Post badge

phil77 earned the Week One Done badge

phil77 earned the One Month Later badge

Important Information

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)