- AEROSOFT COMMUNITY SERVICES

Jump to content

AEROSOFT COMMUNITY SERVICES

AEROSOFT COMMUNITY SERVICES

AEROSOFT COMMUNITY SERVICES

AEROSOFT COMMUNITY SERVICES

Sign In

Email Address

Password

Remember me
Not recommended on shared computers

Forgot your password?

Or sign in with...
Sign Up

weedy0104 earned the Conversation Starter badge

Started a discussion

1 minute ago1 min
Jestersstick earned the One Year In badge

A year since joining

27 minutes ago27 min
brianprice49 earned the First Post badge

Making your first post

53 minutes ago53 min
phil77 earned the Week One Done badge

A week since joining

1 hour ago1 hr

no steering on ground possible

I was waiting long for this release. now its here and not able to do any flight.
rudder doesnt and I cannot make any steering on the ground the nws option doesnt change anything.
I am very angry, every bug would be ok for me, but not be able to steer anywhere with the same settings which work in every other aircraft is very sad.

look yourself:

By weedy0104 · 2 minutes ago2 min
XPNetwork Europa

Du hast Recht, hätt´ich auch drauf kommen können! Danke für den Hinweis.

By stevebiker · 3 minutes ago3 min
Thrustmaster throttle quadrant calibration

OK - I followed the instructions in the PDF, and tried toggling the reverse axis. I think the issue is that on the EFB, when the Bravo levers are in the idle position, the raw values are -1 - not close to zero as I believe it should be. They don't hit zero until somewhere around the climb detent. I'm leaving for a while - will check back in in a few hours. Thank you for your help. BTW - I tried swapping out the Airbus lever for a regular Bravo lever - did not change the behavior.

By brianprice49 · 11 minutes ago11 min
Thrustmaster throttle quadrant calibration

Try turning the invert axis option in MSFS 2024 on or off and try recalibrating after following the advice in the above PDF. I had already tried all of that but the throttles jumped from full reverse to the climb detent completely ignoring the manual throttle zone for the Airbus. Once I toggled the Invert Axis option off and on again then it started working properly after I calibrated again. I don’t have 2020 installed anymore so cannot test it there.

By Andy B. · 44 minutes ago44 min
XPNetwork Europa

Das kannst du doch schnell feststellen: Einfach der Reihe nach die von dir vermuteten "Übeltäter"-AddOns in deiner scenery_packs.ini disablen. Ich verwende "nur" HMK_XPNetwork und simHeaven und stehe auf der 03 in LRBV. In dieser Config ist von Baufahrzeugen nichts zu sehen.

By hmkaiser · 48 minutes ago48 min
Thrustmaster throttle quadrant calibration

Please have a look to the procedure attached.
TCA-A340.pdf

By SimWare · 51 minutes ago51 min

Show More

Total Topics 122k
Total Posts 842.5k

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use

Where:

Search:

Date Created:

Use:

Last Updated:

Chrome (Android)

Tap the lock icon next to the address bar.
Tap Permissions → Notifications.
Adjust your preference.

Chrome (Desktop)

Click the padlock icon in the address bar.
Select Site settings.
Find Notifications and adjust your preference.