In this section you will find all the new releases and updates that are available. It's a closed forum so you are not able to reply, use the dedicated support sections for that
See what Aerosoft is working on right now! Please do not ask for release dates because if we can say we would have posted it here and if we do not know we can't say. Any dates that are given should be seen as indications and not promises.
This is not difficult, but depends on how the developer plans to create the building model. For example, such interior elements as chairs, sofas, all kinds of racks inside the passenger terminal, which have a lot of polygons, can be made in a separate file and included in the configurator so that the user can turn them off at any time. The same applies to animated people.
In my opinion, a minimal set of interior is desirable. Why. Transparent glass, it's beautiful, especially at night. If the glass is made opaque, none of the night textures drawn on opaque glass will look like transparent (semi-transparent) glass through which the terminal room is visible.
For Prepar3D, I will edit the passenger terminal building and add interior elements to the configurator. For MFS, I have not seen configurators and do not know if they do configurators for MFS. I will take an interest in this issue and, if possible, I will also include part of the interior in the configurator.
The problem located - oddly when the Aircraft state is "ready to taxi" everything is a go for a normal flight EXCEPT the Yaw Damper is not engaged. Thus the AP will not function. TOok me hours to find this one.
Steps I did to do this were as follows:
Flight from KBFL to KDFW cold and dark on the ramp,
after getting the APU started, started filling out the flight plan in the FMS. after that is all done, went to clear out a disco in the legs page, freezes at that, everytime I try to clear the disco
just tried again, when clearing the disco's or at least trying to, it freezes up the game.
Can I have a suggestion?
I would like to have the choice of installation. I'm a virtual pilot and I'm mainly interested in the cockpit of the plane, not the interior of the terminal. In my opinion, it is unnecessary to model the interior of the building. The exterior as it was before with the FPS sensitivity would be enough. That's why I would try to add the possibility of choosing the terminal interior yes/no. City yes/no. Would it be possible and not complicated? Please and thank you
I appreciate your work and thank you for it.
Kendy