XP11/12-VR General
Discussions for X-Plane 11/12 with VR compatibility
5 topics in this forum
-
Pinned topics
-
- 0 replies
- 6.9k views
-
Topics
-
- 1 reply
- 2.1k views
-
- 1 reply
- 1.5k views
-
- 2 replies
- 1.4k views
-
- 1 reply
- 1.9k views
-
Popular Topics
-
-
Latest Posts
-
Nein, bei mir klappt die Vernetzung nicht, d.h. der XP12-Flieger taucht in dieser Config nicht in Little Navmap auf. -
-
Scheint zu funktionieren. Ich bin zwar nicht wirklich rumgeflogen, sondern nur auf die Schnelle den Flieger per Map verschoben, die neue Position wird aber in LNM sogleich übernommen. Es scheint sogar LNM 2.8.0 Beta für Ubuntu 20.04 mit XPConnect 2.8.0 Beta für 18.04. zu funktionieren (so hatte ich das vom Entwickler im avsim-Forum verstanden) - d.h., sowohl Lichter als auch Exclusions. -
By Selberfliegenisttoll · Posted
If you change e.g. the Altitude with the mousewheel, you have to make a few turns and than stop short and after that stop you can spin the wheel again for a few turns before you have to stop again. If you do not stop - it will switch from changing hundrets to thousands and you will overshoot your target altitude. That issue is frustrating me since FSX... it is frustrating with the CRJ because if you are in VS or Speed mode changing the altitude, and you "overshoot" -> the AP will switch to ALT because you reach accidently the altitude at which you are currently and the plane will level off. So you have "fast" press VS again and change the altitude to hold the plane in the climb/descent. But sorry, i do not have a solution for that (only turn the mousewheel slowly...) -
Well, i have tested and sadly i can report that i can reproduce that failure. I have started the CRJ 900, Delta Livery, started up the aircraft as i always do (following checklist) and imported a flight plan from simbrief. Eyerything works as it should. After around half an hour in the air, i decide to change the approach and runway (don't ask why, i just wanted so ) So i go in the Legs page of the MCDU and delete all waypoints from approach transition on. Then i press DEP/APPR and the right page opens but at the same moment all systems of the aircraft do freeze. As i told above all switches and rotaries move and give acoustical feedback, but there is no more reaction to any of these. Only rudder, aileron (both without optical feedback) and roll (with optical feddback) seem to work.
-
