When I set the reversers handles on any of the 1, 2, or 4 thruster configurations for jets.  They do not register as a button push on any of those.  What might be the problem?

Ich gebe da gar nichts ein, nur die Wetterdaten.  Ich denke auch, dass die Daten aus einer Datenbank sind, die du aber überschreiben kannst. Auch beim A320 klappt das. Bin mit beiden Fliegern zufrieden.  

It looks like a power issue as if the Xbox wasn't giving enough current through USB. If you have any other controls or USB device, just try if unpluging them would lower the current consumption and if the XPC still disconnects.

Hi everyone, I just bought a brand‑new Honeycomb Alpha Flight Controls XPC, but I’m running into a serious issue when using it with my Xbox Series X and Microsoft Flight Simulator 2024. After plugging it in and launching the sim, the system shows a “controller has been disconnected” message every few seconds. At the same time, the LED lights on the Alpha turn off briefly and then come back on, repeating this cycle continuously. During this period, the controller is completely unusable. What’s strange is that after about 10–20 minutes, the problem suddenly disappears and everything works normally. However, the next day when I power on the Xbox again, the issue returns and the disconnect cycle starts all over. This makes me wonder if it might be related to USB power delivery on the Xbox Series X. I’ve seen other users mention that the XPC should work without any special setup, so I’m not sure if my unit is faulty or if I need to use a powered USB hub to stabilize the connection. Has anyone experienced similar disconnect issues with the Alpha XPC on Xbox? Would using an externally powered USB hub help, or is this likely a hardware defect? Any advice would be greatly appreciated. Thanks in advance!

The AIP does not list or depict in the charts docking systems at T2, you have an official source for the information?    

Visible in the raw values ?

From what I've read,,, these are now B events. Using SPAD.NEXT I've sent a button pushed event B:ENGINE_ASCRJ_ENGS_START_L_KEY_PUSH,,, along with the appropriate release.  However, it does nothing. Can someone please point me in the right direction where I can find more information?  Thank you 

Leider bei mir in Las Palmers volle Schneedecke, bei 19°C. Nach dem Start von X Life, wurde Programm wegen Fehler geschlossen. Erinnert mich an MSFS, ein Loch wird geschlossen, ein weiters geht auf. Damit bleibe ich bei Vorversion. LG Raimund

Hallo, bitte hier nur Neuerscheinungen und Updates posten. Wie der Titel der Rubrik schon sagt... Problembeschreibungen und/oder Lösungen usw dann bitte in der passenden Rubrik posten. Das wäre in diesem Falle hier: https://forum.aerosoft.com/index.php?/forum/1159-x-plane-12-news-und-allgemeines/ Unser Forum wird sonst zu unübersichtlich und hier im Neuerscheinungen und Updates Forum wird kaum nach Problemen... gesucht. Danke Gruß Heinz

Bei mir sieht es so aus: EDDF 23°C, kein Niederschlag, 1022 hPa; GCLP: 18°C, kein Niederschlag, 1026 hPa; kein Schnee an beiden Airports und Umgebung. Einstellung Wetter: reales Wetter, reale Zeit (wobei die Temperatur in Frankfurt ja auch voll daneben liegt).