Tbo 7 Posted March 6, 2022 Share Posted March 6, 2022 Hi, Do you also experience the same thing? Knobs are not responsive when pressed. I have to repeat it multiple times until it get pressed: See video: https://gyazo.com/86056210fd2760bc7d5127c00fcfbb41 Thank you Link to comment Share on other sites More sharing options...
Aerosoft SimWare 730 Posted March 6, 2022 Aerosoft Share Posted March 6, 2022 Are there other controls than buttons affected ? Thank you. Link to comment Share on other sites More sharing options...
Tbo 7 Posted March 6, 2022 Author Share Posted March 6, 2022 I'm not sure, But I also have the feeling the cursor is a bit offset for some other buttons. I have to click not exactly right on the button. Link to comment Share on other sites More sharing options...
GEK_the_Reaper 233 Posted March 6, 2022 Share Posted March 6, 2022 @Tbo mate...this is soo old already and covered at least a dozen of times in this forum. There is even a FAQ about it.... Link to comment Share on other sites More sharing options...
Tbo 7 Posted March 6, 2022 Author Share Posted March 6, 2022 12 minutes ago, GEK_the_Reaper said: @Tbo mate...this is soo old already and covered at least a dozen of times in this forum. There is even a FAQ about it.... Aha I feel dumb if this was it because I knew about this. I didn't flew crj for a while I think this is reason. I'll check again at my next flight. Thanks! Link to comment Share on other sites More sharing options...
Joe Markowski 139 Posted March 7, 2022 Share Posted March 7, 2022 6 hours ago, GEK_the_Reaper said: @Tbo mate...this is soo old already and covered at least a dozen of times in this forum. There is even a FAQ about it.... I'm not sure you should still need to right click if you're using legacy mode instead of lock mode, though. I see the pointer but it doesn't work without right clicking. Link to comment Share on other sites More sharing options...
LesOReilly 314 Posted March 8, 2022 Share Posted March 8, 2022 also for clickspot offsets check that you don't have Lens Correction turned on in settings ... this has been found to cause issues for some as well.. Link to comment Share on other sites More sharing options...
GEK_the_Reaper 233 Posted March 10, 2022 Share Posted March 10, 2022 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.