Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
Hoffie3000

Load and Fuel

Recommended Posts

Hello, why is it not possible to set manually the Trim Data via Scratchboard like the other datas like Pax, Cargo, etc?
It do not accepting letters like "Up or Down". And Numbers only result in a "Bad Format" message.

 

But if I load the complet data via the loadsheet then the required data changes in Trim will accepted.

Any ideas or suggestions here?

Trim1.thumb.jpg.8d05743c34807830460dc328236578a0.jpg

 

Regards, Wolfgang

Share this post


Link to post

Trim on the load and fuel page is a calculated value based on your load and fuel set that should be used in the takeoff performance data.

Share this post


Link to post

But you able to change the TRIM values in the normal MCDU TP PERF page.......

Share this post


Link to post

Great info in the replies. Just a little more info on this.

 

By default the Trim value is set to .8, but it can be calculated in the Fuel Planner and sent to MCDU3.  This is just for the load sheet, you must then enter the Trim in MCDU1 or 2.

 

Best wishes.

 

Share this post


Link to post

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
vor 5 Stunden , DaveCT2003 sagte:

Great info in the replies. Just a little more info on this.

 

By default the Trim value is set to .8, but it can be calculated in the Fuel Planner and sent to MCDU3.  This is just for the load sheet, you must then enter the Trim in MCDU1 or 2.

 

Best wishes.

 

Sorry this is not completely correct. The TRIM value of the MCDU 1 and 2  is automatically updated with the TRIM value from the MCDU 3.......

Share this post


Link to post
Guest
This topic is now closed to further replies.

×
×
  • Create New...