mhron 31 Posted May 28, 2021 Share Posted May 28, 2021 I haven't tried with my Thrustmaster controller yet but I can't control the throttle with my keyboard with keys F2 and F3. The throttle moves but N1 stays at idle until I reach CLB position, then the engines wake up. Plus when the throttle gets over about half way to CLB the key F2 doesn't make it go back but instead it goes forward as if I pressed F3. I tried to fully uninstall the CRJ and install the latest version again but with the same result. Link to comment Share on other sites More sharing options...
DontSync 0 Posted May 29, 2021 Share Posted May 29, 2021 If you look through some of the topics here and your throttle has a single axis, you have to assign Throttle 1 and 2 to the same axis in sim, then on the CRJ EFB set it to dual throttle in config settings. Link to comment Share on other sites More sharing options...
mhron 31 Posted May 29, 2021 Author Share Posted May 29, 2021 Thanks for the reply but I see people having problems with controllers and I just can't get it to work normally on a keyboard with F2 and F3 keys. The levers visually move but from IDLE to CLB positions the engines stay in idle. When it clicks in CLB position then the engines rev up to N1 and N2 values that are expected for that mode. Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3695 Posted May 29, 2021 Developer Share Posted May 29, 2021 Link to comment Share on other sites More sharing options...
Developer Hans Hartmann 3695 Posted May 29, 2021 Developer Share Posted May 29, 2021 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.