Jump to content

Popout MCDU not working


TrainNutter

Recommended Posts

I just updated to today with both non-experimental and 1.2.3.6 and getting the same thing.  Yesterday it was working without problems, now blank popup MDCU. Cannot do Checklist, load fuel, pax ..., Run ground support.  The top panel also has no display.   WTH... every time there is an update there is some major problems with the software.  Frustrating...  Again, I ran update in both non-beta and beta with same results.  YES I pressed the BRT button thinking that was the problem.  I am running P3Dv4.3.   

2019-4-15_10-15-45-514.jpg

Link to comment
Share on other sites

Did you reboot your PC after installation? You should also upgrade tp P3Dv4.4.

43 minutes ago, roncoylejr said:

The top panel also has no display

What do you mean?

43 minutes ago, roncoylejr said:

Again, I ran update in both non-beta and beta with same results

and here?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Guest
This topic is now closed to further replies.
×
×
  • Create New...