Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
Lotus3xiG3

EZCA v2 and Airbus Professional

Recommended Posts

Hi,

 

as you can see in the video below, I am experiencing some some, well, difficulties using EZdok and the Airbus... 

 

https://www.youtube.com/watch?v=xkcFNeXHTQI

 

I have been using EZdok in FSX and P3D v4 for quite some time now and have never run into something like that. Any ideas or suggestions are appreciated!

 

Cheers

Lotus3xiG3

Share this post


Link to post

You are still in the VC view mode in which the fuselage is not rendered for performance reasons. Simply create a view in external view mode.

 

Share this post


Link to post
vor 4 Stunden , f.skywalker sagte:

No Problem,

 

run the EZdoc config Tool again.

You must make this after every new Airplane Installation - update.

 

Frank

Thanks, that did the trick! Didn't know you had to do that, as I've never did that after installing an airplane and never had any problems with that... 

Share this post


Link to post

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
Guest
This topic is now closed to further replies.

×
×
  • Create New...