RoyalToto 8 Posted August 11, 2018 Found an issue today. Doing a short leg and preparing the arrival during the climb. Change in CI during the descend in the CDU results in a change of CI during the climb also. Just to let y'all know. Regards, T Share this post Link to post Share on other sites
Mathijs Kok 32494 Posted August 11, 2018 Okay we'll keep that one in mind. 1 Share this post Link to post Share on other sites
RoyalToto 8 Posted August 11, 2018 Have been reading my post again and to clarify The bus was climbing with ci 50 and i went into the descend page and entered there the ci to 30. Suddenly the bus climbed like an F16. I checked the speed and the bus was way faster than selected. I changed the CI (in the descend page) again and the nose went down. After some investigation, I found out, that the CI on the climb page changed accordingly the CI on the descend page, I did not check the if en route CI changed also. Share this post Link to post Share on other sites
Frank Docter 5254 Posted August 11, 2018 This is fully normal. Airbus only knows one CI. Is this with a Boeing different? Been too long since I flew the 734. Share this post Link to post Share on other sites
RoyalToto 8 Posted August 12, 2018 Well, i tried this in a real world sim and I could choose btwn a climb, enroute and descend path & speed. So i think you should take a look, But it could be also company related. Im not a pilot....... But I have the AOE enroute at the moment and I will acars them and ask Share this post Link to post Share on other sites
RoyalToto 8 Posted August 12, 2018 Ik, got an answer from the flight ALS JE DE CI AANPAST DAN GELDT DIT VOOR ALLE FASE S. STEL JE CLIMB CI IN DAN PAST DE CRZ/DES AUTO AAN. WE KENNEN DUS INDERDAAD MAAR EEN CI. JE KAN WEL GESELECTEERDE SNELHEDEN INDIVIDUEEL AANPASSEN. HOOP DAT DIT HET VRAAGSTUK OPLOST. GR So you where right and this is normal system behavior Issu is solved and can be closed. Tx Share this post Link to post Share on other sites
Frank Docter 5254 Posted August 12, 2018 Mooi mooi, hebben we dat ook weer opgelost. Veel plezier nog met de add on. Groetjes Share this post Link to post Share on other sites
Frank Docter 5254 Posted August 12, 2018 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Share this post Link to post Share on other sites
Emanuel Hagen 5033 Posted August 13, 2018 On 8/11/2018 at 4:19 PM, Frank Docter said: This is fully normal. Airbus only knows one CI. Is this with a Boeing different? Been too long since I flew the 734. Nope, mine does the same. If you want to change the CI during flight you need to go to the PERF INIT and change it there. Obviously that will change it for all phases of flight. Share this post Link to post Share on other sites
