EdS1945 1 Posted July 13, 2018 Share Posted July 13, 2018 Somehow I can not continue the Checklist after "cockpit prep" as "close doors" stays on flashing. Following conditions are set and/or met: Aircraft state at startup: Turn around state Parking brakes: on Chocks: on Load/Fuel page: Boarding, Cargo and Fuel: all steady green Door page: all doors closed. Appreciate any help and/or suggestions Ed Link to comment Share on other sites More sharing options...
Deputy Sheriffs masterhawk 799 Posted July 13, 2018 Deputy Sheriffs Share Posted July 13, 2018 Does “skip item” work? Link to comment Share on other sites More sharing options...
EdS1945 1 Posted July 13, 2018 Author Share Posted July 13, 2018 No, "skip item" option is not available. Link to comment Share on other sites More sharing options...
Ralph_E 1 Posted July 13, 2018 Share Posted July 13, 2018 Exact the same for me :-( After the message "close doors" nothing more happens. Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted July 13, 2018 Deputy Sheriffs Share Posted July 13, 2018 Hi, just one question: Did you use the MCDU 3 menu to close the doors? What shows the MCDU3 DOOR Page? Are all doors in "white"? There are already two topics on this and there fore have a look at Regards, Rolf Link to comment Share on other sites More sharing options...
ggi 3 Posted July 13, 2018 Share Posted July 13, 2018 Yes MCDU3 was used to close the doors. This post is duplicate to the one I started already with the same issue. Link to comment Share on other sites More sharing options...
KIE 20 Posted July 13, 2018 Share Posted July 13, 2018 I had the exact same problem yesterday on my first flight. Using P3D V4.3 on a fresh installed Win10 64Bit with all drivers up to date and all needed Addons installed. Everything else works fine for me. Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted July 13, 2018 Deputy Sheriffs Share Posted July 13, 2018 I will now close this topic because there is another one dealing with the same issue...... Regards, Rolf Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.