Jump to content

Archived

This topic is now archived and is closed to further replies.

wiss

Thrust reversers not stowing

Recommended Posts

Hello everybody 

 

Everytime I land both CRJ-700 and 900 I notice the thrust reversers don't stow after using them (after setting idle thrust or more) . When looking at the model from the outside the reversers stay deployed, although from a functional point of view, the plane and engines seem to work normally, I mean, I don't see a reversers deployed indication on the left EICAS, and I can get full forward thrust if needed, although the reversers still look deployed on the external model. 

 

I use the 1.0.1.1 version on Prepar3D 3.4.22 in Windows 10 64-bit

 

Thanks 

Share this post


Link to post
Share on other sites

Any updates on this issue ?

I also have the same issue with the latest version.

Thanks. Carlos

Share this post


Link to post
Share on other sites

I have noticed the same thing and I just downloaded this aircraft a few days ago. I have not looked at the control settings to see if they are still in the engaged mode that could be the problem.

I will say I use a SAITEK THROTTLE to activate reverse thrust But it is the same thing as pressing and holding F2

Share this post


Link to post
Share on other sites
7 minutes ago, coqui297 said:

Never mind figure it out. Is working well. Thanks

 

Well what was it that you figured out? Maybe someone else might run into the issue and it would be nice to know. 

Share this post


Link to post
Share on other sites

I am unable to see this issue in the 1.0.2 build, can anybody confirm they still see this issue?

Share this post


Link to post
Share on other sites

×
×
  • Create New...