A319 Oil QT below minimum value of 12.0

[CFG874 14]

I fly the A319 V1.1. After the load C&D and turn on the Battery and Instuments occurs as follows.

In the SD Display range Engine value for the amount of Oil the engine is QT with each flight less.

Minimum value of 2 x 12.0, currently in my 2 x 5.8.

I save each flight and start the next in the same Position further.

New load also the A319 does not help.

Can someone help me.

Many thanks

Bernd Reisener CFG874

[Aerosoft Team [Inactive Account] 51558]

Can anybody else confirm this? I could not see this issue.

[CFG874 14]

Hello

Note from me

Create a flight - even during the flight, the amount OIL QT changes with me.

If the flight is then stored, is the next Flight even less available.

Thanks

CFG874

Bernd Reisener

[Cheyenne Chief Pilot 829]

Correct, oil "consumption" during flights is modeled: Just did a flight with oil qt decreasing from 15.9 to 14.7.

Since maintenance isn't modeled you should load a predefined panel state when oil qt has become low.

[CFG874 14]

Hello olli4740

Thanks for the answer.

Only wanted to know whether I make a little bit wrong.

CFG874

Bernd Reisener

[Pip B 1]

Hi, I see that this may be the issue that I have encountered, but what do you mean by a pre defined panel state, I am starting from cold and dark using the second FMS is that what you mean "Pre defined"? if so my low oil problem still occurs after a cold dark start

Pip B