Developer OPabst 2091 Posted December 17, 2009 Developer Share Posted December 17, 2009 Hi, when you use the FS with setting AUTOGEN = NONE (off), it could happen, that at some sceneries objects are missing and not display, maybe only if you fly into an airport. This not only can happen with Aerosoft products! For AES it could happen, that AES is not activ at the airport, even when the airport is activated in AESHelp. When AUTOGEN is ON (Spare or higher) all is fine. This is generated by an FS internal optimize process. Some sceneries use special codeparts to protect the autogen around the airports to be removed, but this code will have a sideeffect by setting Autogen=NONE, so that the FS will ignore that code under this conditions. At the moment it is not clear, if there is a solution to get a fix for Autogen=NONE. Please set the Autogen to Spare or more, related to the speed of you PC to prevent problems here. Link to comment Share on other sites More sharing options...
altena 2 Posted May 5, 2010 Share Posted May 5, 2010 Hello Oliver, Normally I fly with Autogen set at normal. This gives me enough trees and buildings. But, I discovered (it really is the only exception) that on approach at FSDT ZurichX with a PMDG aircraft, no buildings and no trees show up, until I put Autogen slider at none. I can move all sliders more to the left to increase performance, but setting Autogen to sparse then, does not solve the problem. Still no buildings. Jetways are there (guess while I hace AES activated at Zurich). I had (and still have) a long dicussion with Virtuali about this and hope it can be solved. By the way, in this case, also with autogen at none, I'm happy that AES still works at Zurich. Regards Henk Link to comment Share on other sites More sharing options...
VulcanB2 5 Posted July 31, 2010 Share Posted July 31, 2010 Never had an issue (AutoGen OFF). Best regards, Robin. Link to comment Share on other sites More sharing options...
Recommended Posts