Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
JackSwyr

A question about UTC time.

Recommended Posts

As I’m flying right now over JFK at 34K feet, I see my next location will be BAWLL and I’ll be there at 2322 UTC.

It goes down the list like this:

NEWES - 2327

JFK - 2330

RBV - 2336

DQ0 - 2345

And on down the list till I reach KATL which says I’ll be there at 1551.

So I’m confused.  If 2359 is one minute before midnight, 1551 will be 3:51 PM, UTC right?

KBOS and KATL are in the same time zone and the flight isn’t going to take this many hours.

Perhaps I’m confused.

 Thanks 

Share this post


Link to post

Hello Jack,

 

That is a known bug that is slated to be corrected.  This will occur if an arrival runway is not been selected.  For now, simply enter a runway for the arrival airport, and this will allow the FMGS to fully calculate the distance and therefore the ETA.

 

I hope this is helpful to you!

 

 

  • Upvote 1

Share this post


Link to post
41 minutes ago, DaveCT2003 said:

Hello Jack,

 

That is a known bug that is slated to be corrected.  This will occur if an arrival runway is not been selected.  For now, simply enter a runway for the arrival airport, and this will allow the FMGS to fully calculate the distance and therefore the ETA.

 

I hope this is helpful to you!

 

 

Thanks Dave but I had an arrival runway inserted before I even took off.

Share this post


Link to post

Maybe your plan was one or more discontinuity lines?

Share this post


Link to post
8 hours ago, MikaV said:

Maybe your plan was one or more discontinuity lines?

 

That's what I was thinking as well.

 

I'm booting up in a few minutes and I'll see if anything else has changed.

 

Thanks to you both!

 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...