GSalden 43 Posted November 5, 2011 Share Posted November 5, 2011 Hello team, Yesterday I did a tutorial flight with the 737NGX from London Luton to Amsterdam Schiphol. When approaching rw 18R I saw that the mesh was not correct. When pausing and reloading the scenery it went back to normal. This only near rw 18R/36L. If I start a flight from Schiphol everything looks nromal. This morning I did another flight from Heathrow to Schiphol and the same issue appeared. The only thing that has changed the last couple of weeks are the install of SP1 for the 737NGX and the reinstall of the CS 757 with the new v4.6 version. Any suggestions ? Link to comment Share on other sites More sharing options...
GSalden 43 Posted November 5, 2011 Author Share Posted November 5, 2011 I was able to solve it by setting the mesh to 19m instead of 5m and textures to 1m instead of 30cm..... Link to comment Share on other sites More sharing options...
GSalden 43 Posted November 6, 2011 Author Share Posted November 6, 2011 Additional: At Avsim there where other people with the same mesh issue and my solution worked for them too. In the manual from Schiphol it says : - Mesh res 19m - Text res 5m ! ! ! ! ! ! ! ! ! ! However I have scenery made in 30cm res texture and won't be able to see all detail now that I am forced to set it to 60cm or higher and mesh to 19 or higher. AS , is there a solution or workaround for this ? Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted November 6, 2011 Share Posted November 6, 2011 Hello Gerard, Fsx is about compromise sometimes, if you use EHAM then you need too use the advised settings when not use the other settings. Link to comment Share on other sites More sharing options...
GSalden 43 Posted November 7, 2011 Author Share Posted November 7, 2011 Shaun, I modified the Afcad files and am able to use it up to 19m and 30cm now. Link to comment Share on other sites More sharing options...
Recommended Posts