Lep Posted September 19, 2010 Share Posted September 19, 2010 Hi Peter, I've been using the registered Cx for over a week now and am totally awed by the great piece of work. However, I noticed the slipstream turbulence that's turned on in registered copy seems to be rather strongly simulated. I'm comparing this to what I observed in video clips I see, where gliders seemingly fly over mountain/ridge terrains without much of any turbulence in evidence. Mostly I have wind set to about 16 knots. Hope you could share on this issue. Thanks. Lep Link to comment Share on other sites More sharing options...
Peter Lürkens Posted September 19, 2010 Share Posted September 19, 2010 Hi Peter, I've been using the registered Cx for over a week now and am totally awed by the great piece of work. However, I noticed the slipstream turbulence that's turned on in registered copy seems to be rather strongly simulated. I'm comparing this to what I observed in video clips I see, where gliders seemingly fly over mountain/ridge terrains without much of any turbulence in evidence. Mostly I have wind set to about 16 knots. Hope you could share on this issue. Thanks. Lep Hi Lep, it is strong as I can tell you, also in reality. If you like it weaker, reduce the "Turbulence Effect (%)"-setting on the configuration dialog of CumulusX!. best regards, Peter Link to comment Share on other sites More sharing options...
HarryO Posted September 19, 2010 Share Posted September 19, 2010 I think if I were to imagine something awful, it would be flying a glider on the back side of a mountain ridge flying too low in amongst sinking air and turbulence. Icch!!!! Cheers Link to comment Share on other sites More sharing options...
Recommended Posts