ehasanov 4 Posted March 5, 2010 Share Posted March 5, 2010 Hi I tried to finish flight LDZA-EGLL. Every time I had CTD around 20nm inbound BUB (EBBR). I tried to deactivate first Brusseles LC, no progress. Then I deactivate Brussels SC, tried flight again, no CTD. I have 64bit XP with modification of fs9.exe to use >2GB. I must confess, after this modification I don't have OOM, but I have g3d.dll errors. I tried same flight without 3gb patch and this time I had OOM message, again around EBBR(VOR BUB). I run filemon, and EBBR SC looking for files which does not exist in my PC, like: WALLBET_2_LM.BMP, EBBR_03C.BMP etc etc. I'm familiar with all kind of possibilities which could lead to this error, AI a/c textures, LC files etc etc. I don't have any AI aircraft, AI turned off, and no empty texture folders. What could cause this. Thanks Edin Link to comment Share on other sites More sharing options...
Verified Developer OPabst 2091 Posted March 5, 2010 Verified Developer Share Posted March 5, 2010 The files not found are not critical. Check all Sceneries you have on (below) the flightpath you have done, maybe there is the problem. If LDZA is from FSQuality, you can start there, because they have a Memoryleak: http://www.forum.aerosoft.com/index.php?showtopic=19147 Link to comment Share on other sites More sharing options...
ehasanov 4 Posted March 5, 2010 Author Share Posted March 5, 2010 Thanks Oliver. No, I don't have LDZA from FSQ. I read about that. I'm not sure what else could be connected, because when I deactivate EBBR, I don't have CCTD. I will try few more combination. Edin Link to comment Share on other sites More sharing options...
Verified Developer OPabst 2091 Posted March 5, 2010 Verified Developer Share Posted March 5, 2010 Thanks Oliver. No, I don't have LDZA from FSQ. I read about that. I'm not sure what else could be connected, because when I deactivate EBBR, I don't have CCTD. I will try few more combination. Edin When you disable EBBR you have a primitive scenery, which did not need any memory, so no CTD is normal in this case and says nothing. Link to comment Share on other sites More sharing options...
ehasanov 4 Posted March 5, 2010 Author Share Posted March 5, 2010 When you disable EBBR you have a primitive scenery, which did not need any memory, so no CTD is normal in this case and says nothing. Hi , another question. Again with EBBR active, CTD around 30nm inbound BUB, heading 300DEG. Why crashed because I monitored mem usage and it was around normal values for PMDG B747 (900000K). g3d.dll!! Then I tried to TO from EBBR and fly to approximate position with same distance and heading from BUB and no CTD this time. Strange?! Thanks Link to comment Share on other sites More sharing options...
Recommended Posts