magna91 7 Posted April 22, 2020 Share Posted April 22, 2020 Good morning, Yesterday I was given the saitek throttle block. I tried to set the two levers for the throttles for the engine 1 and 2 through Fsuipc (both for A320 and for A330), but if I set the direct command through calibration of Fsuipc, the engine levers only work as Reverse and do not give engine power. How can I do to be able to assign the engine power control to the two levers? Thanks Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted April 23, 2020 Aerosoft Share Posted April 23, 2020 Have you read the throttle setup manual? Link to comment Share on other sites More sharing options...
magna91 7 Posted April 24, 2020 Author Share Posted April 24, 2020 Hello Mathijs, yes I have read. But I think I a problem of Fsuipc. If I set the MAX and min from the axis calibration, the throttle work only in the reverse mode. If I don't set axis in the the axis calibration, the throttle work pretty good but with the two axis not synchronised at the 100%. For don't open another topic, I write anothe problem (I think) with Fsuipc6: After have installed Fsuipc 6, now the copilot when ask Flap 1 or any flaps, set always Flap Full. If I reinstall Fsuipc5, this problem don't exist. It's possible check? Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted April 27, 2020 Aerosoft Share Posted April 27, 2020 Best to report that in the section on the checklist. Sounds strange though. Link to comment Share on other sites More sharing options...
DaveCT2003 2553 Posted April 27, 2020 Share Posted April 27, 2020 On 4/24/2020 at 12:59 AM, magna91 said: Hello Mathijs, yes I have read. But I think I a problem of Fsuipc. If I set the MAX and min from the axis calibration, the throttle work only in the reverse mode. If I don't set axis in the the axis calibration, the throttle work pretty good but with the two axis not synchronised at the 100%. For don't open another topic, I write anothe problem (I think) with Fsuipc6: After have installed Fsuipc 6, now the copilot when ask Flap 1 or any flaps, set always Flap Full. If I reinstall Fsuipc5, this problem don't exist. It's possible check? I think that is due to a setting in FSUIPC (must use "Send to FS as Normal Axis"). Check the Throttle Setup Manual in our documentation. I have to say though, I don't recommend using FSUIPC for setting up controls. The only reason on the earth to do this is if you have very noisy pots. Best wishes! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.