VRE001 0 Posted November 1, 2019 Hello Guy's I want to use an altitude constraint, but I can not make a constraint between 2 flight levels Exemple : This waypoint AKDAM have contrainte FL70 to FL140 I want contraint FL90 to FL160 so i type FL160-FL090 but when i click on "ALT CSTR" i have a error "BAD FORMAT" What is the correct syntax for apply constraint between 2 flight level Best regards Share this post Link to post Share on other sites
Emanuel Hagen 5033 Posted November 1, 2019 If I'm not totally mistaken a manual entry for a between constraint is not possible. 1 Share this post Link to post Share on other sites
DaveCT2003 2282 Posted November 1, 2019 2 hours ago, Emanuel Hagen said: If I'm not totally mistaken a manual entry for a between constraint is not possible. This is true. It has to be entered as an exact altitude for manual entries. I wish it was more like Boeing/MD, but it's not. Share this post Link to post Share on other sites
Herman 955 Posted November 1, 2019 This looks like it should go in the "regular" MCDU support section (Navigation\Autoflight) rather than the Settings/Options MCDU one, so I moved it. The subheading for the Navigation\Autoflight section reads, "If you want to get some help on navigation and MCDU procedures, here is tyhe [sic] place." Share this post Link to post Share on other sites
Emanuel Hagen 5033 Posted November 1, 2019 1 hour ago, DaveCT2003 said: This is true. It has to be entered as an exact altitude for manual entries. I wish it was more like Boeing/MD, but it's not. Boeing can't do it either, it's really only MD and Bombardier who do it. I woulnd't know what to use it for anyway. Share this post Link to post Share on other sites
