Sabretooth78 56 Posted July 11, 2019 Just a minor problem here: during takeoff and initial climb (i.e. times of high fuel flows) the ECAM displays don't properly show values with 5 digits. I see this with both IAE and CFM models: IAE: CFM: Share this post Link to post Share on other sites
Mathijs Kok 32494 Posted July 11, 2019 What is your screen resolution? Share this post Link to post Share on other sites
Mathijs Kok 32494 Posted July 19, 2019 In that case the scaling of windows is not working as expected. Share this post Link to post Share on other sites
DaveCT2003 2290 Posted July 19, 2019 I run at the same resolution ( 3840 x 2160 ) and I don't have any issues. Also, I don't think the fuel flow should ever show 5 digits, only 4. I've pasted a screen shot below. I would try to reinstall the Airbus (be sure to disable computer security and run the installer "As Admin". You might also try downloading the latest graphics card drivers, wiping your graphics card drivers using DDU and then install the latest graphics drivers. Let us know how you make out. Share this post Link to post Share on other sites
Sabretooth78 56 Posted July 19, 2019 I did actually just do a video driver reinstall, and with DDU to chase another issue, so I'll pay more attention next time! If it ultimately requires a reinstall of the Airbus I'll just wait until there's a bigger update requiring a reinstall... It typically only goes 5-digits during the takeoff - certainly not in any other phase. Share this post Link to post Share on other sites
masterhawk 466 Posted September 5, 2019 It might be well a bug. With lbs/h we have bigger numbers as with kg/h. Will check. Share this post Link to post Share on other sites
masterhawk 466 Posted September 5, 2019 confirmed, LBS setting problem 2 Share this post Link to post Share on other sites
