CptV 13 Posted June 1, 2015 Share Posted June 1, 2015 Hello! In PERF page when we set flaps for take off, trim position stays always to 0.8Up, but we can change that. Is there a document for trim position for take offs? Link to comment Share on other sites More sharing options...
Deputy Sheriffs The Dude 6537 Posted June 1, 2015 Deputy Sheriffs Share Posted June 1, 2015 You can use the CG that the fuelplanner calculates and also displays in the R MCDU. Just look at your trimwheel, there is a scale for the CG and the corresponding trim setting in units. Dail in the CG, read off the trim unit that goes with that and type that into the PERF TAKE OFF page. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.