How to setup buttons of the Aerosoft Truck Wheel to open/close the front doors in OMSI

[SimWare 823]

Please login to display this image.

How to setup buttons of the Aerosoft Truck Wheel
to open/close the front doors in OMSI

The default button mode on the Aerosoft Truck Wheel Shifter module is TOGGLE.

This means that once pressed, the button state remains the same until you press the button again.
If this button is assigned to a toggle function (a function that requires a single ON/OFF impulse to change state)

then you will need to press the button TWICE each time for the function to work.
 

For instance, you would need to press the button twice to open the doors in OMSI
and then press the button twice again to close the doors.

 

We simply need to change the button mode from TOGGLE to MOMENTARY.
The “Aerosoft Truck & Bus Wheel Profiler allows us to do that.
 

You can download it from here : https://wheel.aerosoft.com/index_en.php

 

Buttons 7 & 8 will be used to open/close the front doors in OMSI.
Button 7 : 1^st Wing

Button 8 : 2^nd  Wing

STEP 1 :

Connect the wheel and start the Profiler

Set the button #7 to Momentary mode

Please login to display this image.

 

STEP 2 :

Set the button #8 to Momentary mode

Please login to display this image.

STEP 3 :

Start OMSI and go to Options -> Game Controller
Select Truck Simulator Gear in the Connected Game Controllers panel

Select Button #7 and set the Ident field to “Front Door, 1^st Wing Open/Close”

Please login to display this image.

STEP 4 :

Select Button #8 and set the Ident field to “Front Door, 2nd Wing Open/Close”

Please login to display this image.

STEP 5  :

Press OK and load a bus in the game.
Make sure you enable the “Station Brake & Door Release ON/OFF” function

      --> You can press the numpad “-“ key to do so
 

You are all set !