How to configure the Honeycomb Bravo Throttle with the MSFS Aerosoft Airbus A330

[SimWare 747]

Please login to display this image.

How to configure the Honeycomb Bravo Throttle
with the MSFS Aerosoft Airbus A330
This tutorial shows how to configure the Honeycomb Bravo Throttle 
with the Aerosoft A330 for Microsoft Flight Simulator.

We will cover 4 points :

- 1 - Assigning the spoilers
- 2 - Assigning the throttle axes and reversers
- 3 - Assigning the flaps

- 4 - Assigning  the landing gear

Please login to display this image.

 

IMPORTANT NOTES : 
1 - Make sure the ASSISTANCE settings are set to TRUE TO LIFE !
2 - Make sure no other control device (Joystick, yoke, etc.) has any axis assigned to any throttle function.
 

STEP 1 :
In Flight Simulator, go to OPTIONS -> CONTROLS.
1- Select the BRAVO THROTTLE QUADRANT TAB and create a new empty
     profile. Name it "AS-A330" for instance

2 – Assign the SPOILER AXIS function to the speedbrake lever
3 – Assign the FLAPS AXIS function to the flaps lever

4 – Assign the THROTTLE 1 AXIS and THROTTLE 2 AXIS to the
      two middle throttle levers
5 - The Bravo Throttle reversers need to be triggered by inputs.
      The Bravo levers axes don’t give axis signal in the reverser portion.
      Assign the  THROTTLE 1 DECREASE and THROTTLE 2 DECREASE functions
      to the detents at the bottom of each throttle lever.
      (With the Airbus Pack, the small reverser flaps need to be raised
       to unlock the detents)
Note that the REVERSE AXIS box has nothing to do with the reversers

but is only a signal polarity inversion needed with some devices.

Please login to display this image.

 

IMPORTANT NOTE : Make sure the sensitivity curve of all the axes is linear and reactivity is set to 100%
 

Please login to display this image.

 

STEP 2 :
Assign the GEAR UP and GEAR DOWN functions to the gear lever

Please login to display this image.

 

STEP 3 :
IDLE – CLIMB – FLX/MCT – TOGA should be correctly calibrated from the start.
Please make sure the default settings are active in the EFB
Pan/zoom to the EFB, click anywhere in the EFB screen to switch it up.
Click on the little cog wheel in the upper-right corner.

Please login to display this image.

 

STEP 4 :
The Settings screen appears

IMPORTANT : 

Do NOT attempt this calibration when the EFB is undocked.
When undocked, the focus isn't in the main simulator window anymore
and the controls (throttle, yoke, etc.) are disabled making the calibration impossible.

Instead, do this procedure in the virtual cockpit.

Please login to display this image.

STEP 5 :

Click AIRCRAFT

Please login to display this image.

STEP 6 :
Make sure the “Custom throttle calibration” parameter is set to OFF.

à Parameters are automatically saved upon change.

Please login to display this image.

You are all set !

[Ramp_air 401]

Thanks for this tutorial

[DaniilBaree 6]

Cool!

[SimWare 747]

42 minutes ago, Pilotefr said:

Thanks for this tutorial

 

21 minutes ago, DaniilBaree said:

Cool!

EFB tutorial is currently worked on.

[SimWare 747]

On 2/26/2023 at 8:46 PM, DaniilBaree said:

Cool!

 

On 2/26/2023 at 8:24 PM, Pilotefr said:

Thanks for this tutorial

Here you are :