nobleord 1 Posted January 8, 2022 Share Posted January 8, 2022 Hi, Got new Honeycomb yoke and throttle. For the PMDG 737 NGXu, I am trying to use the flap handle on the quadrant (lever 6). The flaps will move, but not for the full range. If I set to fully extended, the flaps only go to 30. Then if I move the lever all the way up, they only retract to 1. I tried to do a calibration in P3D, but that did not seem to make any difference. I have the profile from this site loaded. Any suggestions? Thanks, Bryan Opalka Link to comment Share on other sites More sharing options...
Aerosoft SimWare 731 Posted January 10, 2022 Aerosoft Share Posted January 10, 2022 Dear Sir, Did you also set the sensitivity to max and the null zone to zero in the simulator? Best regards. Link to comment Share on other sites More sharing options...
nobleord 1 Posted January 13, 2022 Author Share Posted January 13, 2022 Thank you... that did the trick! I am quite the newcomer to the world yoke/throttle controls and all the setup of them. Thanks, Bryan Link to comment Share on other sites More sharing options...
Aerosoft SimWare 731 Posted January 13, 2022 Aerosoft Share Posted January 13, 2022 Hi Bryan, Glad it now works. Have fun flights. Link to comment Share on other sites More sharing options...
Aerosoft SimWare 731 Posted January 13, 2022 Aerosoft Share Posted January 13, 2022 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.