Transair 22 Posted April 29, 2021 Share Posted April 29, 2021 Hi I have struck a problem with not being able to change the altitude select by using the incremental knob on the Bravo. After a lot of testing this seems normal on other aircraft but not possible with the CRJ. All other AP functions work normally with the CRJ. To put it another way, I can change the selected altitude on the a/c itself via the glareshield altitude knob but not through the Bravo. any ideas welcome! Link to comment Share on other sites More sharing options...
Transair 22 Posted April 29, 2021 Author Share Posted April 29, 2021 Hi As a follow up to above, I also cannot configure any switches on the Bravo or in fact the Alpha yoke, to the CRJ. I don't use Spad/FSUIPC so if that's the case, is it that elements of the Honeycomb gear will not fully bind to the CRJ yet or at all? Is it an objective of Aerosoft to enable this in due course? Link to comment Share on other sites More sharing options...
cyguy 1 Posted April 29, 2021 Share Posted April 29, 2021 Link to comment Share on other sites More sharing options...
Transair 22 Posted April 29, 2021 Author Share Posted April 29, 2021 greatly appreciated. Thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.