bhorv67 12 Posted May 5, 2020 Share Posted May 5, 2020 After each engine start up, engines go to full power (N1 is at full power and engine noise sounds at full). Throttle controls are set visibly at idle in the VC. If I move throttles to CL position, engines (and sound) go back to idle N1. I tried to reset the aircraft state to cold & dark and go through the entire startup procedure again, but having the same issue. Not having this problem in any other dev planes (haven't tried any other variant of airbus yet). My external devices are controlling the airbus throttles visibly properly. I can't figure what could be causing the issue. I haven't changed any control mapping or made any setting changes. Appreciate any help, thanks Link to comment Share on other sites More sharing options...
bhorv67 12 Posted May 5, 2020 Author Share Posted May 5, 2020 Update - A full restart seems to have fixed the issue. I think what happened was I initially loaded an A319 that for whatever reason didnt load the VC. Something must have been wrong with the repaint file. I then switched to another A319 and that's when the issue happened. Apologies if I missed that in the manual, but it should be noted if its not as a matter of procedure - don't switch from one Airbus to another airbus in the same sim session. Link to comment Share on other sites More sharing options...
DaveCT2003 2553 Posted May 5, 2020 Share Posted May 5, 2020 Excellent! Thanks so very much for updating your post! Best wishes for Happy Flights my friend! Link to comment Share on other sites More sharing options...
DaveCT2003 2553 Posted May 5, 2020 Share Posted May 5, 2020 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.