Jump to content
Sign in to follow this  
lamont

FlightKeeper Woes

Recommended Posts

This may have been addressed before so bare with me. I've followed the tutorial and have completed sucessful flights but lately I'm not getting the full info at the end of a flight. It also seems that I have two current flights each time. This is my procedure:

1. Start FK

2. Run FSAutoStart

3. Create flight, including loading a FS flightplan

4. Start ActiveSky4.5 and load a new route for weather

5. Connect FK to FS

6. Fill-in PAX and CARGO and change TA if required

7. Obtain FK weather, decode and save

8. Minimize FK

9. Continue with flight

I have set Release Parking Brakes as start time and Set Parking Brakes and Shutdown Engines as end time.

If I'm doing something wrong or out of order, please let me know. Thanks

Lamont Duncan

COO CityLink

Chief Pilot PWA

VATSIM PRC Support Staff

Share this post


Link to post
Share on other sites

Hi,

I am sorry, but I don't get what your exact problem is. Which infos are you missing and what do you mean with "It also seems that I have two current flights each time."?

Regards

Thomas

Share this post


Link to post
Share on other sites

Hi Thomas,

I'll try to be a bit more clear. When I finish a flight FK doesn't seem to finish. Incomplete info is flight time, fuel used, etc.

If I click on disconnect it asks me if I want to abort the flight and if I say yes then another current active flight is there with all the info. This is what I meant by two flights.

Just to let you know I may have solved the problem by not loading a FS flightplan in FS and manually loading a plan into FK. Perhaps doing both was causing the problem.

Thanks for the reply.

Lamont Duncan

COO - CityLink

Chief Pilot - PWA

VATSIM PRC Support Staff

Share this post


Link to post
Share on other sites

OK. This indicates that you are not reaching the end of flight, which means that you don't fulfill the end of flight trigger requirements (e.g. parking brakes set and engines off). This can be configured in the FSFK options (general tab). Please check that you choose the right mode for you.

Hope this helps

Thomas

Share this post


Link to post
Share on other sites

Hi Thomas, I have engines off, parking brake set as the end of flight trigger. I'll re-check to make sure. Thanks for the help.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...