Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

Archived

This topic is now archived and is closed to further replies.

Avio

Damage Modelling

Recommended Posts

Understand that the engine damage modelling is included, but have not actually experience it in sim. How is the damage really modelled? Is carb icing modelled too? And when the engine does get damaged (or degraded), how does one reset it to brand new condition again?

About carb icing, in the real Dimona, when shutting engine at high altitude, wouldn't that cause any icing to form?

Kindly advise. Thanks.

Share this post


Link to post

In this case you made everything correct so far. Normally the engine protects itself. If you pull the prop controll cirquit breaker before take off for example, the engine will overspeed and give up after a while. However you can use overspeeding for a little extra power when needed on short runways.

The real Dimona does not suffer from carb icing because the carburetors are behind the rear cylinders in a pretty warm environment. Not the best place to get a good performance but protected against icing. This is one of the reasons why the Dimona does not need a carb heater.

Share this post


Link to post

For very detailed advice about carb icing, search in the Diamond Katana forum where there is a lengthy thread about Rotax carbs,

Not the same as the Limbach engine but pertinent background information nonetheless.

Carb ice does not form because the engine is shut down.

Share this post


Link to post
Guest
This topic is now closed to further replies.

×
×
  • Create New...