jfri 1 Posted July 9, 2012 Everything works as expected when I load the tutorial 1.pln flightplan into the CDU. But my own 12.pln refuse to load. I rightclick 1 and the orange light lights up. Waypointselector is 1. I press "1" and "2" and the display says 12. I press the INSERT key. Orange light goes out and turn grey and the red WARN light lights up Share this post Link to post Share on other sites
Bjorn Comhaire 27 Posted July 19, 2012 Everything works as expected when I load the tutorial 1.pln flightplan into the CDU. But my own 12.pln refuse to load. I rightclick 1 and the orange light lights up. Waypointselector is 1. I press "1" and "2" and the display says 12. I press the INSERT key. Orange light goes out and turn grey and the red WARN light lights up Hi, Most important question: when you check the waypoints, did they load? If you flightplan has 9 waypoints or less, it loads in one go and you will see the red light meaning that the complete flightplan was loaded... Björn Share this post Link to post Share on other sites
jfri 1 Posted July 19, 2012 Hi, Most important question: when you check the waypoints, did they load? If you flightplan has 9 waypoints or less, it loads in one go and you will see the red light meaning that the complete flightplan was loaded... Björn Here I have discovered that the problem was that I tried to load a FS9 flightplan file. When creating a FSX xml file it loaded. Share this post Link to post Share on other sites
Bjorn Comhaire 27 Posted July 20, 2012 Here I have discovered that the problem was that I tried to load a FS9 flightplan file. When creating a FSX xml file it loaded. Ah great to hear you were able to solve this one! Björn Share this post Link to post Share on other sites
