Heronjr 2 Posted August 8, 2023 Share Posted August 8, 2023 Yesterday SIMtarter could start P3D normally. Today, I press the Run Profiler button, check the ATIS, it goes to Step 11 (skipped) and goes back to Flight Control Center. Would you mind tell me what could happened in less than 24hs? I did no touch anything because I am a newby. I tried only to set a starting position. Thanks for your attention. Link to comment https://forum.aerosoft.com/index.php?/topic/176676-after-one-day-p3d-not-starting/ Share on other sites More sharing options...
Verified Developer Capt. PERO 398 Posted August 13, 2023 Verified Developer Share Posted August 13, 2023 Please post a DebugPack. Link to comment https://forum.aerosoft.com/index.php?/topic/176676-after-one-day-p3d-not-starting/#findComment-1113058 Share on other sites More sharing options...
Verified Developer Capt. PERO 398 Posted August 20, 2023 Verified Developer Share Posted August 20, 2023 Any update? Link to comment https://forum.aerosoft.com/index.php?/topic/176676-after-one-day-p3d-not-starting/#findComment-1113342 Share on other sites More sharing options...
Verified Developer Capt. PERO 398 Posted August 24, 2023 Verified Developer Share Posted August 24, 2023 Looks like this is fixed. Topic close. Please open a new one if required. Link to comment https://forum.aerosoft.com/index.php?/topic/176676-after-one-day-p3d-not-starting/#findComment-1113462 Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.