Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
Sign in to follow this  
Heinz Flichtbeil

Tromsö ENTC and Ortho4XP

Recommended Posts

Hello,

 

there was a small mistake in some manuals for Tromsö and the theme "Ortho4XP" (Page 17).

Stairport Sceneries has send us the following corrected text:

 

Copy the DEM.rar file in "Aerosoft - ENTC Tromso - Mesh" to a temporary folder and extract the included files.

Delete the folder "Aerosoft - ENTC Tromso - Mesh" afterward if you already have installed it into the Custom Scenery folder.

Open the Ortho4XP.cfg and add ENTC to the “do_not_flatten_these_list”. Should look like this: do_not_flatten_these_list = [‘ENTC’]

Start Ortho4XP and select and build the tile +69+018 as usual, EXCEPT next step.

Do this instead:

In step 2 select “Custom DEM file” and navigate to the extracted .tif file and select the one of your current tile.

In step 2 lower your “Curv_tol” setting to get a reasonable amount of mesh triangles. A setting 2.4 results in aprox. 4 million triangles. The screenshots were made with a setting of 0.8 resulting in aprox. 8 million triangles.

When the build process is finished make sure that the zOrtho4XP_+69+018 entry is below the “Aerosoft - ENTC Tromso - Airport” entry in the scenery_packs.ini.

 

We will actualize the manuals .....

Greets Heinz

Share this post


Link to post
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...