Jump to content


This topic is now archived and is closed to further replies.


Cannot get Flight1 GTN stack visible

Recommended Posts

Minor problem but a bit irritating,

When I run the GTN config for other airplanes, I can have the GTN stack always visible in the top corner of the screen.

If I change views it can remain visible if I add type=special to the appropriate section of the panel config file.


For the twin otter, despite these settings, the stack will not appear. Instead I have to use shift+5 to pop up the 750 unit. I can cope with using the mouse when flying, but the keyboard takes away some of the immersion.


Has anyone else had this issue or hopefully solved it?

Share this post

Link to post
Share on other sites

  • Create New...