Domobaby 0 Posted July 5, 2016 Share Posted July 5, 2016 Evening, I have a problem exactly as described here: 1. I have reinstalled v1.31 2. P3DV3.2 2. Simconnect.msi in the "redist" location of P3D have been installed again 3. FSUIPC (free version) is updated to 4.955 The problem; 1. Load aircraft from P3D start up screen 2. Set state CLD and DRK 3. Turn BATT ON 4. Turn EXT PWR ON 5. Parking Brake ON 6. Try to select Cargo door LSK 7. Instead it toggles the Front Left OPEN/CLOSE Same happens if I start up in "TURNAROUND" mode. Instead I cannot close the Cargo doors. The LSK's just toggle the FRONT LEFT which is on the opposite side. Please note I can open and close the right hand pax doors ok. I cannot open or close the left hand pax aft door. Link to comment Share on other sites More sharing options...
Domobaby 0 Posted July 5, 2016 Author Share Posted July 5, 2016 PROBLEM FOUND If I remove FSUIPC4.DLL I can now control the doors. This will have a knock on impact I'm sure with other addons for my virtual airline. What is going on here? Version 4.955 (Unregistered) of FSUIPC causes the Cargo Doors to be rendered useless. Link to comment Share on other sites More sharing options...
Domobaby 0 Posted July 7, 2016 Author Share Posted July 7, 2016 Good to see Aerosoft Support Staff are monitoring this forum - I have reinstalled Simconnect from the SP2 redist area - Reinstalled the Airbus - Updated to P3DV3.3 - Checked my dll.xml in appdata and programdata to check FSUIPC wasn't double referenced When I press the Cargo door on MCDU it still only controls the front left door. I cannot open therefore load any Cargo now into the Airbus because the "Cargo" payload on the loadsheet is always greyed out. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.