Jump to content

Majestic Dash 8 Yoke and Throttle profile with working Gear and AP Leds 1.0.0

   (0 reviews)

About This File

I have modified  Dendarian's  Alpha and Bravo json profiles to make the "Gear" and "Auto Pilot" Leds functional. I also made changes to some of the warning indicators. Starter Engaged and Low Volts extinguished and Door now functional.

Dendarian's XML file and pdf for control and axis defaults remain valid except for my following changes.

Alpha

Button 1 now resets VC pan

Button 2 disengages all AP modes currently set

Button 3 Sets spoilers to "Taxi" mode and also enables "Steering" switch

Button 4 Sets spoilers to "Flight" mode

Bravo

Flap Switch "Up" release "Down" Set Park Brake

Auto Pilot Switches remain the same but I have made many changes to the way these are programmed.  IAS, ALT and VS can't be engaged together (as far as Led indications go). Same goes for HDG, NAV and APP. Due to limitations in being able to read AP mode, back from the MJC8Q400 aircraft, the sim pilot needs to keep an eye on the VC panel to keep AP mode and Led indications correctly aligned with the aircraft's panel.  Eg: On climbing to the "selected altitude" in VS mode the PFD will change from VS to ALT and begin maintaining level flight but the Bravo's AP IAS Led will remain lit until the ALT button is pressed.

I don't believe Majestic Software have provided sufficient warning or status outputs  to do much better than I have but, never the less, I welcome any feedback / enhancements anyone has to offer.

 

The imported the Alpha and Bravo profiles are named as

Majestic-Dash-8-A-Yoke and Majestic-Dash-8-B-Throttle

so will not overwrite Dendarian's original profiles.

 

 

 


For which Simulator

P3D V5
  • Like 2
 Share


User Feedback

You may only provide a review once you have downloaded the file.

There are no reviews to display.

×
×
  • Create New...