joernjkrueg 0 Posted October 17, 2014 Share Posted October 17, 2014 Hi, my 318/319 works fine. One minor Problem. When I have both checklists Pilot/Copilot actvated, flaps are going allways to full or zero. Command soundss right, "flaps two", but it goes for full flaps? Joern Link to comment Share on other sites More sharing options...
Guest Posted October 17, 2014 Share Posted October 17, 2014 Please refer to the exact moment when this happens - so have a look into the Vol6 StepbyStep Guide and tell me at which item exactly this happens that flaps are set by the copilot to full instead of two...... By the way are you using any other software like FSCrew, or do you assign any key on your joystick to flaps or changed a keyboard assignemt in your FSX settings? Regards, Rolf Link to comment Share on other sites More sharing options...
Max Reverse 344 Posted October 17, 2014 Share Posted October 17, 2014 I had the same, some time ago. The solution is, not to assign any axis to the flaps. Hope it helps Link to comment Share on other sites More sharing options...
Guest Posted November 12, 2014 Share Posted November 12, 2014 Becauswe until now no answer was received I assume that the problem has been solved and will close this topic. Regards, Rolf Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.