Airbus X extended Fly by wire problem

[arbaz 0]

Hello,

I've recently got Airbus X extended for fsx v1.15, when i installed the aircraft everything went as expected, the aircraft loaded up nicely without any problem but when i start the flight in mid air to test out the aircraft controls (the fly by wire system) it acts bizarre. As soon the fsx loads up the plane it starts doing some weird maneuvers like ailerons and rudder moving left and right automatically, ive no control over the aircraft it turns where ever it likes but when i move the joystick, i get control over it and as soon as i give no command to plane through joystick it again starts acting in same way, or if i leave the aircraft level after getting the control over it then after few seconds it starts turning in its own directions again even though i give no commands to it. it looks like aircraft is jumping or shaking in the air. I also have airbus a318/a319 and experienced the same thing but when i turned off the fly by wire system in this aircraft it was flying normally. so i figured it out it is FBW fault. Ive joystick with dual analogue. ive searched many times for this problem but couldnt find the solution. if there is something wrong with my calibration with joystick pls let me know or do i have to calibrate through FSUIPC which i already have it. Any help will be appreciable.

[ozanc 0]

do you set the throttle to climb thrust after take off?

[Malick51 1]

Hmmm. Tough issue, hopefully you have it fixed by now.

If not, what is your FPS? When my frames get really low, thats when the aircraft is completely unresponsive. That was atlas for the extended, as I just got the updated one.

Find your FPS by clicking control-Z or control-Y I'm not sure which one.

Hope this helped.