barbarotto1 1 Posted April 24, 2011 Share Posted April 24, 2011 Hi all im new on this site, read all articles tried everything and downloaded new launcher and tried new config.tool -still huey x rudders in virtual view dont move-they respond but only briefly -left rudder take off till air spead reaches 60 knots then helo-centers itself-right rudder for landing about 40% torqou on collective...maybe they should make a patch with self installer to fix this problem...on outside view for example with engines off tried rudder input but it moves only a little then snaps back to center, unlike the promo video which shows full control left/right etc.-i have pmdg 747/cheyenne/seahawk/ and the HUEY-X---I USE KEYBOARD FOR RUDDER-will some day buy peddels-any help?with this huey-x issue?thanks Link to comment Share on other sites More sharing options...
Snave 466 Posted April 24, 2011 Share Posted April 24, 2011 Firstly you might want to re-title the topic - you do not have rudder pedals so your heading is misleading. If you can't use a twistgrip function for rudder, then check that autorudder is not enabled - almost all who don't have rudder pedals use this function and it is not compatible with helos. Next check that your button controls are correctly assigned Finally, buy rudder pedals. That will solve the (non-)issue... Link to comment Share on other sites More sharing options...
barbarotto1 1 Posted April 24, 2011 Author Share Posted April 24, 2011 thanks- however i dont use auto rudder and the- post title- means/refers to vc view -pedals dont visually move at all and according to other posts on this topic rudder peddels or not most people have the same problem eighter no movement visual or in practice-i will keep searching for solution Link to comment Share on other sites More sharing options...
HarryMudd 0 Posted April 28, 2011 Share Posted April 28, 2011 I had a similar problem that was caused by the Service Pack 2 install.Did you install SP2?-Harry Link to comment Share on other sites More sharing options...
barbarotto1 1 Posted April 29, 2011 Author Share Posted April 29, 2011 thanks-yes SP 1/2 BOTH installed FSVIPC-unregistered-i have some control-main is visual-none movement Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted May 1, 2011 Share Posted May 1, 2011 thanks-yes SP 1/2 BOTH installed FSVIPC-unregistered-i have some control-main is visual-none movement The newer launcher should be out soon with the dll's to accompany the Joystick Config Tool. Link to comment Share on other sites More sharing options...
Recommended Posts