Babak Amirani 1 Posted August 6, 2021 Share Posted August 6, 2021 Hi. I have installed the Honeycomb Bravo throttle on x plane 11 on my mac . I am receiving warning of “Multiple axes assigned for throttle 1 & 2” . Running Cessna and other planes the throttle 1&2 do not work. Tried uninstalling and installing the software, shutting down the PC removing the hardware and reinstalling them back . no success. Need assistance please! Link to comment Share on other sites More sharing options...
Babak Amirani 1 Posted August 6, 2021 Author Share Posted August 6, 2021 Problem solved !! I used to have a Saitek yoke with the Saitek pro flight throttle quadrant attached to the yoke. Before installing the new Honeycomb Bravo throttle I just carelessly disconnected the Saitek throttle, with the yoke still connected to the mac. To resolve the matter: 1) Disconnect the Honeycomb throttle. 2)Reconnect the Saitek throttle to the yoke. 3) In Xplane 11 joystick setup change saitek throttle axes 1, 2 and 3 to None 4) Reconnect Honeycomb Bravo throttle quadrant to the mac. 5) Everything works perfectly!! Reason of problem: The previous settings were stored in x-plane 11 memory. It should have been cleared before connecting the new quadrant. Thank you Link to comment Share on other sites More sharing options...
Aerosoft SimWare 730 Posted August 6, 2021 Aerosoft Share Posted August 6, 2021 55 minutes ago, Babak Amirani said: Problem solved !! I used to have a Saitek yoke with the Saitek pro flight throttle quadrant attached to the yoke. Before installing the new Honeycomb Bravo throttle I just carelessly disconnected the Saitek throttle, with the yoke still connected to the mac. To resolve the matter: 1) Disconnect the Honeycomb throttle. 2)Reconnect the Saitek throttle to the yoke. 3) In Xplane 11 joystick setup change saitek throttle axes 1, 2 and 3 to None 4) Reconnect Honeycomb Bravo throttle quadrant to the mac. 5) Everything works perfectly!! Reason of problem: The previous settings were stored in x-plane 11 memory. It should have been cleared before connecting the new quadrant. Thank you Hi Babak, Thank you for this feedback. As a general rule, when connecting a new device, when other devices are already in use, check the assignments of all the devices to cancel any redundancies. When a device is connected, the simulators make automatic assignments. But they don't check if other devices are already connected. They simply assume the device you just connected is the only one in use. This can lead to multiple redundant assignments. Have a good weekend. Link to comment Share on other sites More sharing options...
Babak Amirani 1 Posted August 6, 2021 Author Share Posted August 6, 2021 3 hours ago, SimWare said: Hi Babak, Thank you for this feedback. As a general rule, when connecting a new device, when other devices are already in use, check the assignments of all the devices to cancel any redundancies. When a device is connected, the simulators make automatic assignments. But they don't check if other devices are already connected. They simply assume the device you just connected is the only one in use. This can lead to multiple redundant assignments. Have a good weekend. Thanks a lot for your comment. I really had a hard time to find out what’s going on. Anyway in case some other guy faces the same problem , it may help him/her. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.