Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content

slod

members
  • Content Count

    10
  • Joined

  • Last visited

Community Reputation

0 Neutral

About slod

  • Rank
    Flight Student - Groundwork

Recent Profile Visitors

635 profile views
  1. I've had the same problem. It varies dependent on which aircraft I load first. A quick work around appears to be assigning a key to the "Hydraulic failure" in P3D and pressing that. Seems to restore Hydraulic pressure for me.
  2. slod

    Autopilot

    Thanks for replying Michael, I read the manual as ‘not simulated’ rather than not on the real thing. Great job on the EPR by the way. For the first time since the Dreamfleet 727 it’s a pleasure to (try and) fly by the numbers! Thanks for the detailed response. Regards
  3. slod

    Autopilot

    Hi, Really enjoying the plane so far. One question: Will you be simulating the "IAS/Mach" hold mode in future updates? - that's quite a difference maker for me. I imagine it's quite a challenge to program as a lot of 'reasonably priced' simulations fail to include it, but to me this great plane deserves a fully functioning autopilot. If I had seen the manual first I would have checked, but that's my fault I know! Thanks in advance.
  4. Thanks for your reply Mathijs. The list of LVARs exists and is available with SPAD.next, I think the issue for some of us (me at least) is understanding which commands are used for what. The following example would work with the Airbus to reduce the heading, but doesn't seem to work with the CRJ. I believe Hans mentioned in another thread that he would explain the descriptions when he had time, but I'm sure he had plenty of other things to get on with. Other commands (Altitude var etc.) work fine) Thanks LVAR:ASCRJ_FCP_HDG_CHANGE" Value="1" ValueOperation="Decrement"
  5. Thanks for your suggestions. I always run P3D with Administrative rights and my profile saves fine with ‘flying tips’ disabled - only CRJ enables them again. It it doesn’t happen with any other aircraft so I assumed it was something written into the CRJ. I’ll keep looking for something I’ve missed. Thanks
  6. Hi, I'm almost too embarrassed to ask this as I'm sure I'm missing something - but for the life of me can't find it. I have the default P3D 'Flying tips' switched off, but every time I load the CRJ they are switched back on. I've searched the manual for a configuration setting but can't find anything. For clarification. I'm talking about the "To start engine pres Ctrl+E" messages etc. Thanks to anyone who can point me in the right direction!
  7. This would be really helpful for me also.
×
×
  • Create New...