When installing the CRJ Pro for P3Dv5, I got an error message at the end of the installation procedure about something to do with P3Dv4 (which I also have), although I can't remember the exact message now.
I haven't installed the CRJ in P3Dv4. This resulted in the add-on.xml not being created. I therefore manually created this, using an add-on.xml file found under the CRJ installation folder, moving this to a documents/Prepare3d v5 Add-ons/Aerosoft CRJ Pro v5 folder and updating the paths to the xml file accordingly. Doing this, I can now see the CRJs in P3Dv5.
However, when I load a CRJ I cannot seem to get any power, although I'm not sure if this is an installation issue or because I do not know this aircraft and cannot get the power started. The engines seem to be running, but no power is available.
I then tried to uninstall using the uninstaller created under the Prepar3D v5 Add-ons folder (why is this not under the Aerosoft CRJ Pro v5 folder?), but when I run that it says "ERROR: Missing log file!!" and I cannot continue.
If I re-run the installer, it shows the following settings , which don't seem correct (it has taken my MSFS installation folder as my P3Dv5 installation folder):
Please advise on how I can uninstall and install again correctly.
P.S. I also have the MSFS Aerosoft CRJ installed, without issues.
P.P.S. Seems to be in a "cold and dark" state, with the yoke locked and no power. However, engines are running - I can apply thrust using the F2,3,4 keys and the aircraft moves, although the throttle in the UI doesn't move to reflect this. Cockpit is very dark and difficult to see anything....I need access to the EFB which I can't seem to get....