stratfordman

Export issues into PMDG aircraft

Recommended Posts

I have just installed P3D v4 having uninstalled version 3.

 

I have used PFPX for some time and have had no issues in exporting my flight plans to my PMDG aircraft.

 

This morning I have tried to load a flight plane and completed the whole process except for the fact the the flight plan did not show up in my aircraft and nor did my previous flight plans apart from one which was LOWW to EGLL which I cannot even remember compiling.

 

I therefore need some assistance to enable me to export into PMDG.

 

I am obviously doing something wrong but not sure what it is.

 

Many thanks in advance.

 

 

Michael

Share this post


Link to post
Share on other sites

Hi,Thanks for your reply.

 

I am not very techy and therefore I am unsure about how to send a screenshot.

 

Anyway,basically when I export a flightplan it goes into my PMDG flightpan folders and also the 777 folder so PFPX is exporting the flightplans OK.

 

The issue is that when I click on Co.Route in the FMC they are not there for some reason.

 

I do not know whether or not this additional information may help.

 

Michael

Share this post


Link to post
Share on other sites
snoopy1212    0

Have you tried exporting them into the PMDG RTE folder?

 

That's what I do right now and it works perfect for the 747!

 

(BTW sorry to piggyback on this thread but do you know how to export to AS4? Thks!)

Share this post


Link to post
Share on other sites
srcooke    184
12 hours ago, stratfordman said:

Anyway,basically when I export a flightplan it goes into my PMDG flightpan folders and also the 777 folder so PFPX is exporting the flightplans OK

 

This is the Prepar3D v4/PMDG/Flightplans/777 folder and not v3?

 

The flight is computed & released before export ?

 

Share this post


Link to post
Share on other sites
srcooke    184
1 hour ago, snoopy1212 said:

BTW sorry to piggyback on this thread but do you know how to export to AS4? Thks!

 

AS4 imports the  sim .pln file

 

Share this post


Link to post
Share on other sites

Hi,

 

Again thanks for your reply.

 

My flightplan folder is P3D/PMDG/Flightplans and also 777.

 

I have both RTE and RT2 flightplans in there.

 

When I have completed my flightplan in PFPX I then export it as usual and then finally release the plan.

 

One point of interest is that although my new sim is P3D v4 which is shown in the sim ,on my C drive it just shows up as P3D no version 4 is attached to it even though I do have version 4 files shown within my PC.

 

Anyway any further observations would be welcome.

 

Michael

 

Share this post


Link to post
Share on other sites
srcooke    184

Remove the RTE2 entry that is overiding RTE1 and try again

 

P3Dv4 is not yet supported. However setting the Path to the sim as P3Dv4 will suffice

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now