aviateur22 3 Posted September 6, 2010 Share Posted September 6, 2010 hello again I've remark on the ecam APU page , that after pressing the APU master switch to oFF after engine start up that it was still furnishing AIR+ELECTRICAL all light on the overhead panel are extinguishes thks a lot to yu brgds Link to comment Share on other sites More sharing options...
conchulio 20 Posted September 6, 2010 Share Posted September 6, 2010 hello again I've remark on the ecam APU page , that after pressing the APU master switch to oFF after engine start up that it was still furnishing AIR+ELECTRICAL all light on the overhead panel are extinguishes thks a lot to yu brgds As far as i know, the APU as a cooldown time, so it won't immediately shut down but keep on running for certain time. Although i am not sure if aerosoft have modeled this. Link to comment Share on other sites More sharing options...
TB10 Driver 17 Posted September 7, 2010 Share Posted September 7, 2010 As far as i know, the APU as a cooldown time, so it won't immediately shut down but keep on running for certain time. Although i am not sure if aerosoft have modeled this. That is correct, there is a 3 minute cool down period modeled. Bob Link to comment Share on other sites More sharing options...
aviateur22 3 Posted September 10, 2010 Author Share Posted September 10, 2010 yes you right after 3 minutes , APU is Off , every think is ok thks a lot good day Link to comment Share on other sites More sharing options...
Recommended Posts