Bruce R
-
Posts
21 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Bruce R
-
-
I was flying in New Zealand, NZAA - NZDN. The crash was just at TOC, after about 20 mins or so flying time. At that point of the flight I would have been approx 10 miles off the west coast of NZ’s North Island heading south. The only scenery nearby is ORBX NZNI. That’s scenery of the whole North Island. I think I’ll stick with Wolfgang’s theory. I’ll certainly let you know if it persists when using default scenery.
Cheers,
Bruce R
-
Yes, you could be right. I’m using the beta version for ActiveSky in P3D v 4.5. I hope that is the cause because I enjoy the CRJ. I’ll do a few flights without ActiveSky and see how I get on.
Cheers
Bruce R
-
This is just for your information. I'm on W10, 2004 update. P3D v4.5 HF3. I installed your CRJ Pro v2200 this morning. First flight was fine, and was using ActiveSky at the time. After re-booting the computer and loading up another flight with the CRJ, I had just reached FL34 and the computer crashed with no warning. I was using ActiveSky again. Event Viewer shows the following;
Faulting application name: Prepar3D.exe, version: 4.5.14.34698, time stamp: 0x5e94b5c2
Faulting module name: ntdll.dll, version: 10.0.19041.207, time stamp: 0xcad89ab4
Exception code: 0xc0000374
Fault offset: 0x00000000000fdec9
Faulting process id: 0x1278
Faulting application start time: 0x01d64f55b9fb5897
Faulting application path: C:\Lockheed Martin\Prepar3D v4\Prepar3D.exe
Faulting module path: C:\WINDOWS\SYSTEM32\ntdll.dll
Report Id: d5bb943d-e7d9-4d55-a816-82537ae29f2d
Faulting package full name:
Faulting package-relative application ID:
In my case having an ntdll.dll crash is rear. As stated, this is your your information only. I don't expect you to do anything.
Regards
Bruce R
NZ
-
8 hours ago, Greg Moore said:
Changed the numbers and now it works fine!
Hello Greg. Would you let us know what FS2Crew said so we can check our aircraft.cfg files - thanks.
Bruce R
-
With the original version of the CRJ it's important to load a default aircraft first, and once that's all loaded at your airport/gate, change to the CRJ. I used to have the same problem as you're having, and I'm sure I read somewhere in the manual to load a default aircraft first. It certainly fixed it for me.
Bruce R
-
Try loading a default aircraft first with engines running. Once loaded at your airport switch to the CRJ. You can then change the panel state of the CRJ through Dave. I have a feeling this may be mentioned in the manuals.
Bruce R
-
Are you loading a default aircraft first? I had a similar problem. Nothing happened after I pressed a start button. After reading the manuals again I saw you had to load a default aircraft at your airport, then load the CRJ. I haven't had the same problem since.
Bruce R
-
It's very good. Much appreciated. Thank you.
Bruce R
CRJ Pro V2400 Update Problem (Unless in Safe Mode)
in General discussion and support
Posted
I spent the whole morning trying to install the CRJ - until I read Ron's topic. Putting the computer in safe mode worked for me as well. I wasn't able to copy and paste the registration number, so a word of warning, print it out first then go into safe mode and enter the rego manually.
Bruce R