sumnersd 2 Posted January 16, 2015 Share Posted January 16, 2015 I loaded up KLAX and AES starts as it should. The problem I have is the ground crew are about 8 in. deep into the pavement. I start up GSX and no problem. The only thing that has changed is I just loaded ORBX global base. Any ideas? Thanks. Link to comment Share on other sites More sharing options...
Aerosoft Jonas S. 466 Posted January 16, 2015 Aerosoft Share Posted January 16, 2015 Is AES above the mentioned scenery in the scenery config? (besides the fact that it always should be at the very top) You can run AESHelp.exe, this will detect the issue and resolve it. Jonas Link to comment Share on other sites More sharing options...
sumnersd 2 Posted January 17, 2015 Author Share Posted January 17, 2015 AES is at the top. Will try the AESHelp.exe. thanks Link to comment Share on other sites More sharing options...
sumnersd 2 Posted January 18, 2015 Author Share Posted January 18, 2015 I ran AESHelp.exe, Wasn't sure which category to run,so I ran the airport button,then did a resync and repair. No luck. Jetway,AES vehicles, and ground crew still set too low. Link to comment Share on other sites More sharing options...
sumnersd 2 Posted January 18, 2015 Author Share Posted January 18, 2015 for now, I have disabled KLAX from AES. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.