Throttle issues (GF-TQ6 and Saitek Throttle Quadrant)
If you are using FSUIPC read the attached document. Please note FSUIPC is NOT needed for the CRJ and we do not advise to use it's throttle options for the CRJ.
If you are not using FSUIPC start by calibrating your controls, heck even if you do use FSUIPC calibrating them every few weeks is a very good idea.
Unless there is an absolute need, we advise you not to install any drivers or other software that comes with the controls.
9% of the time they are not needed and often cause
![Aerosoft Team [Inactive Account]](https://forum.aerosoft.com/uploads/monthly_2023_09/Aerosoft_Social_Media_Profilbild_Neu23.thumb.jpg.03721825e6a434ed4af0c8b2b73a5898.jpg)
Yes, I made it compatible, but at a cost. Here's what I did:
Calibrated the TQ6 via Windows' "Devices and Printers" control panel:
Please login to display this image.
I rebooted my system and started P3D v4 I checked the value range of the TQ6 axes with FSUIPC 5 (registered)Please login to display this image.
Please login to display this image.
As you can see, even after calibration the available range is still much smaller than the full -16384 to 16383 rang